Dual Installations - Sub-Zero ICBB-36R Design Manual

Integrated Refrigeration
Cabinetry Applications
The illustrations below show typical applications of framed
and frameless cabinetry. Refer to the full-scale templates
at the end of this section for specifics on door openings.
CABINET INTEGRATED
UNIT
DOOR PANEL
3 mm
REVEAL FINISHED
OPENING
Framed—full overlay.
UNIT
CABINET
DOOR
PANEL
3 mm
REVEAL
FINISHED
OPENING
Framed—beaded inset.
CABINET INTEGRATED
UNIT
DOOR PANEL
3 mm
REVEAL FINISHED
OPENING
Framed—standard overlay.
CABINET INTEGRATED
UNIT
DOOR PANEL
3 mm
REVEAL
FINISHED
OPENING
Frameless cabinetry.

Dual Installations

Two integrated units may be placed side by side in a dual
installation. Depending on the models specified, opening
widths will be 1372 mm, 1600 mm or 1829 mm. Panel
width dimensions will vary slightly from single installations.
Refer to the chart below for typical panel dimensions. The
dimensions are based on a 3 mm reveal. A reveal of up to
6 mm is possible with adjustments to panel dimensions.
Typical Panel Dimensions
686 mm MODELS
Door
Top Drawer
Bottom Drawer
914 mm MODELS
Door
Top Drawer
Bottom Drawer
A dual installation kit is required for installations with 51
mm or less space between the units. Dual installation kits
are avail able through your authorized Sub-Zero dealer.
IMPORTANT NOTE: If a 686 mm unit is installed next to a
914 mm tall unit, the decorative front panels will align,
however, the face frames will not. This is only apparent
when both doors are open at the same time. Due to a
more robust hinge on 914 mm units, the face frame was
reconfigured to maintain a consistent overall panel height.
Refer to the illustration below.
Face frame alignment.
48
W H
681 mm 1153 mm
681 mm 345 mm
681 mm 424 mm
W H
910 mm 1153 mm
910 mm 345 mm
910 mm 424 mm