3.11. SHIFT LEVER
If the SHIFT LEVER SWITCH is not showing an input in the TEST MODE, replace the switch. Remove the
Shift Lever Unit and apply grease to the mechanism's sliding portion once every three months.
· When performing work, be sure to turn power off. Working with power on can cause an
electric shock or short circuit.
· Use care to ensure the wiring is not damaged. Damaged wiring can cause electric
shock or short circuit.
· This operation should only be carried out by QUALIFIED SERVICE PERSONNEL
3.11.1. REMOVING SHIFT LEVER
1. Turn the Power Switch OFF.
2. Open control panel. Refer to Section 3.10.1
3. Disconnect two connecters on shifter loom.
4. Close the Control Panel and re-secure.
5. Remove the four tamperproof screws, lift out the Shift Lever Unit and withdraw it completely.
7. Reinstall in reverse order, ensuring the 'D' is at top.
31