Troubleshooting - Sega Crazy Taxi High Roller Installation & Service Manual

3.16. TROUBLESHOOTING

· Only QUALIFIED SERVICE PERSONNEL should carry out these procedures.
If a problem occurs, first check the wiring connections.
PROBLEMS CAUSE
When the main switch The power is not ON.
is turned ON, the
machine is not
activated
Incorrect power source/voltage.
AC Unit CIRCUIT PROTECTION
DEVICE (ie; fuse) was activated due to
an instantaneous overcurrent.
The colour image on Incorrect monitor adjustment.
the screen is incorrect.
The on-screen image The power source and voltage are not
of the monitor sways correct.
and/or shrinks.
Sound is not emitted. Sound volume adjustment is not correct. Adjust the volume setting - refer to Section 5
Malfunctioning BD and Amp.
Connector connection is incorrect.
The fluorescent Fluorescent lamp(s) needs replacement. Replace the fluorescent lamp(s). Refer to Section
lamp(s) does not light
up.
The connector is disconnected.
Steering Wheel does Steering Wheel deviation.
not operate
satisfactorily .
Steering Wheel Volume malfunctioning.
ADJUST GEAR's engagement in not
correct.
SHIFT LEVER doesn't Switch malfunctioning.
operate satisfactorily.
Operation of Accel & VR position deviated.
Brake Pedals is not
satisfactory.
VR malfunctioning.
ADJUST GEAR's engagement is not
correct.
COUNTERMEASURES
Firmly insert the plug into the outlet.
Make sure that the power supply/voltage are correct.
First, remove the cause of overcurrent and reinstate
the circuit protection device to its original status.
Then identify the cause of the fault on the item which
caused the overcurrent & fix.
Make appropriate adjustments. Refer to the Monitor
Service Manual supplied with this product.
Make sure that the power supply and voltage are
correct.
Perform Sound Test to check it. Refer to the Service
Manual supplied with the Game Board.
Check connector connection from Base to
Speaker/Woofer
3.10
Check connections - refer to Section 3.10.
Adjust Volume value in the TEST MODE.
Replace the Volume (see Section 3.7).
Adjust the engagement of ADJUST GEAR (see
Section 3.7).
Replace the switch (see Section 3.8).
Adjust the VR value in the TEST MODE.
Replace the VR (see Section 3.9).
Adjust the adjustment of ADJUST GEAR (see
Section 3.9).
43