Maintenance Checklist - Snorkel TM12 Service Manual

DAILY PREVENTATIVE MAINTENANCE SCHEDULE
MAINTENANCE TABLE KEY
Y = Yes/Acceptable
N = No/Not Acceptable
R = Repaired/Acceptable
COMPONENT INSPECTION OR SERVICES
Operator's Check that the operators manual is in
Manual the manual holder and all pages are
intact and readable
Labels & Check that labels and decals are in
Decals place, intact and readable
Entire Unit Perform pre-operation inspection
Check for and repair any damage
Electrical Check cables and wiring harness condi-
system tion (No wear or physical damage)
Battery Check electrolyte level, (if applicable).
System
Check battery cable condition
Check terminals are clean and connec-
tors are tight
Check charger condition and operation
Charge batteries
Hydraulic Check oil level
Hydraulic
system no leaks
Drive motors Check for operation and leaks
Hydraulic
pump no leaks
Emergency Check emergency lowering correctly
lowering (See emergency lowering procedure)
Controller Check condition and operation
Platform Check fasteners are in place, correctly
deck and tightened and not damaged
rails
Check the structure and welds for dam-
age, deformation, corrosion and cracks
Check condition of deck (no damage,
deformation, corrosion or cracks
Check entry gate closure functions
correcly
Table 2-2: Daily preventative maintenance
checklist
TM12

MAINTENANCE CHECKLIST

Date: ______________________________
Owner: _____________________________
Model #: ____________________________
Serial #: ____________________________
Serviced by: _________________________
Y N COMPONENT
R
Elevating
assembly
Chassis
Lift Cylinder
Wheels
Harness
anchor point
System func-
tion inspec-
tion
Emergency
stops
Brakes
Horn
Proximity
switch and
controller
* NOTE: Use ISO #46 during summer
and ISO #32 during winter
PREVENTATIVE MAINTENANCE REPORT
INSPECTION OR SERVICES
Inspect for external damage, dents, loose
rivets or cracks, loose chain tensioner
locknuts
Check the structure and welds for dam-
age, deformation, corrosion and cracks
Check cables for pinch or rubbing points
Check the structure and welds for dam-
age, deformation, corrosion and cracks
Check for leaks
Check for loose components
Check for damage to tyres
Check fasteners are secure
Check for damage, deformation, corrosion
and cracks
Conduct system function inspection (see
system function inspection pocedure)
Check that the emergency stop button on
the basket panels opertates correctly
Check that the emergency stop button
on the ground control panel operates
correctly
Check that the brakes operate correctly
Check that the horn sounds when acti-
vated
Check armguard lowering functions cor-
rectly when the platform is being lowered.
Check full drive speed range is enabled
when the platform is stowed.
Check that only reduced drive speed
range is enabled when the platform is
elevated.
Y N
R
Page 2 - 21