Controls/Pre-Operation - Snorkel TM12 Service Manual

CONTROLS/PRE-OPERATION

CONTROLS AND INDICATORS
2
PLATFORM
CONTROLLER
3
ESC
PRE-OPERATION AND SAFETY INSPECTION
NOTE: Carefully read, understand and follow all safety rules, operating instructions, labels
and National Safety Instructions/Requirements. Perform the following steps each day be-
fore use.
1. Open the chassis door and inspect for damage, fluid leaks or missing parts.
2. Make sure the platform is fully lowered before checking the level of hydraulic fluid.
Open the chassis door to gain access to the hydraulic tank.
Check that the fluid level is between the minimum and maximum level marks indicated on
either the side of the hydraulic tank or on the dipstick (if fitted).
The dipstick (if fitted) can be found on the bottom of the filling cap.
Add recommended hydraulic fluid if necessary using specifications set on page 24.
3. Check that the A.C. extension cord has been disconnected from the chassis outlet.
4. Check that the fluid level in the batteries is correct to that stated under "Battery maintenance"
on page 20.
5. Verify that the batteries are charged by checking the % value under BCI on the EZcal display
as shown on figure 2-3.
6. Check that all guardrails are in place and all fasteners are correctly tightened.
7. Inspect the machine thoroughly for cracked welds and structural damage, loose or missing
hardware, hydraulic leaks, damaged control cable and loose wire connections.
Page 2 - 8
4 9
1
10
L
ENTER
5
8
FIGURE 2-3: Controls and indicator locations
1 JOYSTICK
2 EMERGENCY STOP
3 LIFT/DRIVE SELECT SWITCH
4 LOW BATTERY INDICATOR
5 EMERGENCY STOP (CHASSIS)
CHASSIS
CONTROLLER
6
KEY
6 PLATFORM RAISE/
LOWER SWITCH
7 ENABLE SWITCH
8 KEYSWITCH
9 HORN BUTTON
10 EZcal DISPLAY
7
TM12