8-5) Parameter Setting Mode ････････8-12 - FujiFilm RYB500S3-VBC User Manual

8
KEYPAD PANEL
8-5) Parameter setting mode
In the parameter setting mode, parameters can be edited.
Press the MODE key to display
parameter.
After selecting the target parameter, press the ∧ or ∨ key to select the parameter number to be edited first.
Press the ENT key to edit the parameter setting.
(1) Parameter
The parameter includes two types: those for which the change is reflected on the servo amplifier and
servomotor immediately, and those for which the change is reflected after the power is turned off and
on again.
(2) Indication and editing
The indication and editing methods for parameter are as follows.
- Value indication
The most significant digits that can be edited are indicated first.
Example: Parameter #1 (Setting range: 1 to 32767, Initial value: 8)
Because the number of digits that can be edited is five (32767),
Initial indication
Most significant
digits
To clarify the number of digits of the value, zero is not indicated at places that cannot be edited.
To move among the digits, press the MODE key while holding down the SHIFT key.
, and press the ENT key for 1 second or more to select the desired
SHIFT SHIFT SHIFT SHIFT
ENT ENT
ENT ENT
(1 sec or more)
MODE MODE MODE MODE
ESC ESC ESC ESC
Middle Least significant
digits digits
ENT (1 sec or more)
ESC
ENT (1 sec or more)
ESC
ENT (1 sec or more)
ESC
is indicated first.
The lit decimal point indicates the current
editing position (among the most significant
digits, middle digits and least significant digits).
8-12