LonWorks
The LonWorks board includes two LEDs to
display the communication status of the
Card
board, display the state of the N
Diagnostic
and respond to the network management
LEDs
Status LED
The Status LED patterns are:
ON
Flashing 10 times per second
Flashing intermittently
Flashing 5 times per second
OFF
Service LED
The Service LED displays the state of the
N
EURON
Service LED patterns for various states and
defines their meaning.
MG.60.N2.02 - VLT is a registered Danfoss trademark
There is power on the board but
there has not been any
communication to an input network
variable in the last 2 seconds.
There is regular network
communication to the VLT's input
network variables.
There is network communication to
the VLT's input network variables but
input network variables are received
at a period greater than 2 seconds.
The response to the network
management "Wink" command. The
VLT LonWorks node must be reset to
leave the wink state.
No power on board or hardware fault.
chip. The following table shows the
VLT
®
5000 / VLT
"wink" command. The onboard LEDs are the
Service LED (LED 1, red) and the Status LED
chip,
(LED 2, green).
EURON
®
6000 HVAC / VLT
®
8000 AQUA
LEDs
23