Operation - Olympus DELTA 50 Quick Start Manual

5.4 Lower Status Bar

6. Operation

This chapter describes a typical operational sequence for the DELTA handheld XRF analyzer.
6.1 Typical Operating Procedure
To use the instrument
1. Insert a charged battery into the analyzer handle.
2. Turn on the analyzer using the I/O switch.
3. Read the radiation safety notice (see ), and then confirm that you are a certified user.
System initialization begins immediately.
The analyzer launches a test screen using the last selected mode (see Figure 6-1 on page 15).
4. If the mode is to be changed:
a) Go to the Home screen.
b) Select the Mode button.
c) Choose the desired mode.
5. When the "Cal Check Required" message is displayed, place the analyzer in the docking station.
6. Navigate to the Test Setup screen, and then tap the Cal Check button (see Figure 6-2 on page 16).
Progress bar and text message
System OK/ready
Figure 5-5 Lower status bar
Figure 6-1 Test screen
103076-01EN [U8998318], Rev. C, June 2014
System time
Operation 15