Olympus DELTA 50 Quick Start Manual page 11

The status of the second docked battery (either charging = red or full = green) is also shown on the battery indicator located
on the left rear side of the docking station.
4.2.2 Charging Batteries Using the Battery Charger
The battery charger is a standard accessory with the DELTA Element and DELTA Inspector models. It is an optional
accessory for all other models.
The charger takes about two hours to completely charge a battery. The battery charge status is indicated by two lights on
the power adaptor.
Left light (green only)
On — Flashing
On — Solid
Off
Off
4.3 Hot Swap for a DELTA Battery
A battery hot-swap capability is a standard feature with the DELTA handheld XRF analyzer. You can remove and replace a
battery without having to shut down, restart, or perform a Cal Check.
A "shutdown" status display gives the percentage of internal charge remaining when the battery is removed (see
Figure 4-3 on page 11). If the internal charge reaches 0, insert a new battery and then, restart the analyzer with the I/O
switch. If the red X-ray indicator lights are flashing, the battery voltage is too low.
Figure 4-2 Battery charge status
Right light (red only)
Off
Off
On — Solid
Off
Figure 4-3 Shutdown status
103076-01EN [U8998318], Rev. C, June 2014
The battery is charging.
The battery is charged.
Error. Remove the battery, and then place it back on the
charger. If the error persists, call Olympus Technical Support.
There is no battery on the charger.
Status
Instrument Batteries 11