I/O Memory Of Watchdog Timer; Programming Notes - Epson S1C63656 Technical Manual

4.2.3 I/O memory of watchdog timer

Table 4.2.3.1 shows the I/O address and control bits for the watchdog timer.
Register
Address
D3 D2
0 0 WDEN WDRST
FF07H
R
*1 Initial value at initial reset
*2 Not set in the circuit
*3 Constantly "0" when being read
WDEN: Watchdog timer enable register (FF07H•D1)
Selects whether the watchdog timer is used (enabled) or not (disabled).
When "1" is written: Enabled
When "0" is written: Disabled
Reading: Valid
When "1" is written to the WDEN register, the watchdog timer starts count operation. When "0" is written,
the watchdog timer does not count and does not generate the interrupt (NMI).
At initial reset, this register is set to "1".
WDRST: Watchdog timer reset (FF07H•D0)
Resets the watchdog timer.
When "1" is written: Watchdog timer is reset
When "0" is written: No operation
Reading: Always "0"
When "1" is written to WDRST, the watchdog timer is reset and restarts immediately after that. When "0"
is written, no operation results.
This bit is dedicated for writing, and is always "0" for reading.

4.2.4 Programming notes

(1) When the watchdog timer is being used, the software must reset it within 3-second cycles.
(2) Because the watchdog timer is set in operation state by initial reset, set the watchdog timer to disabled
state (not used) before generating an interrupt (NMI) if it is not used.
S1C63656 TECHNICAL MANUAL
CHAPTER 4: PERIPHERAL CIRCUITS AND OPERATION (Watchdog Timer)
Table 4.2.3.1 Control bits of watchdog timer
∗1
D1 D0 Name Init
∗3 ∗2
0 –
∗3 ∗2
0 –
WDEN 1
R/W W
∗3
WDRST Reset
1 0
Unused
Unused
Enable Disable
Watchdog timer enable
Reset Invalid Watchdog timer reset (writing)
EPSON
Comment
27