Identify The Parts Of The Producer Iv; Parts Information; Discwatch Status Light; Operator Panel - Rimage Producer 8200N User Manual

Identify the Parts of the Producer IV

Parts Information

DiscWatch Status Light

The Producer IV is equipped with a status light that indicates various
conditions. The table below illustrates status light states and explains the
conditions indicated by each state.
Light State System Condition
Green The system is operating properly. No jobs are
light on currently processing.
Green The system is operating properly. Jobs are
light currently processing.
blinking
Yellow The autoloader is waiting for the software to start.
light on
Yellow The front door may be open. Close the front door
light to allow jobs to process.
blinking
Red light The carousel is out of blank discs. Fill the supply
on bins with the appropriate media type.
A system error requires operator intervention.
Check the client workstation or control center for
a message.
An equipment error occurred at initial start up,
such as a missing carousel. Check the client
workstation or control center for a message.
2002543_A

Operator Panel

The Operator Panel has a four-line display that informs you of operations
or conditions that require operator intervention, including the consumable
status. The four-line display includes:
•
•
•
•
After initialization, the Producer IV displays the name of the embedded
PC. Refer to the
information.
Tip: The caret symbol '^' in the upper right corner of the operator panel
indicates that the Rimage software is currently communicating with the
autoloader.

Operator Button

Open the front door to access the operator button. Press the operator
button to rotate the carousel and position a bin so that discs can be loaded
or unloaded. Each time you press the operator button, the carousel rotates
to the next bin.
Tip: The carousel will rotate to a bin only after the autoloader has
completed initializing.

Disc Dispenser

The disc dispenser moves discs into the output bin.

Beeper

The Producer IV has a beeper that sounds when user intervention is
required. Read the error message that displays on the operator panel or on
your PC monitor and take appropriate action to correct the problem. Refer
to the
For more information visit rimage.com/support
Line 1: System name
Line 2: ITS (retransfer ribbon) count and CMY ribbon count
Line 3: Bin configuration
Line 4: Quantity of discs in each bin
Operate Gemini Utilities
Enable the Beeper section on page 13 for beeper setting options.
section on page 13 for more
8