Speaker Simulator - Roland XV-3080 Owner's Manual

Hi Gain
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance (Effect Balance) #
Sets the volume balance between the source sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Pan (Output Pan)
Adjust the stereo position of the delay sound. A setting of
L64 is far left, 0 is center, and 63R is far right.
Level (Output Level)
Adjust the output level.

52:SPEAKER SIMULATOR

Speaker Simulator is an effect that simulates the speaker type
and mic settings used to record the speaker sound.
fig.2-62
L in
Speaker
R in
Speaker
Speaker Type
Select the type of speaker. The specifications of each type are
as follows. The speaker column indicates the diameter of
each speaker unit (in inches) and the number of units.
Type Cabinet
SMALL 1 small open-back enclosure 10
SMALL 2 small open-back enclosure 10
MIDDLE open back enclosure
JC-120 open back enclosure
BUILT IN 1 open back enclosure
BUILT IN 2 open back enclosure
BUILT IN 3 open back enclosure
BUILT IN 4 open back enclosure
BUILT IN 5 open back enclosure
BG STACK 1 sealed enclosure
BG STACK 2 large sealed enclosure
MS STACK 1 large sealed enclosure
MS STACK 2 large sealed enclosure
METAL STACK large double stack
2-STACK large sealed enclosure
3-STACK large sealed enclosure
L out
R out
Speaker Microphone
dynamic mic
dynamic mic
12 x 1 dynamic mic
12 x 2 dynamic mic
12 x 2 dynamic mic
12 x 2 condenser mic
12 x 2 condenser mic
12 x 2 condenser mic
12 x 2 condenser mic
12 x 4 condenser mic
12 x 4 condenser mic
12 x 4 condenser mic
12 x 4 condenser mic
12 x 4 condenser mic
12 x 4 condenser mic
12 x 4 condenser mic
Chapter 2 Using the XV-3080 Effects
Mic Set (Mic Setting)
Adjust the location of the mic that is recording the sound of
the speaker. This can be adjusted in three steps, with the mic
becoming more distant in the order of 1, 2, and 3.
Mic:Dir (Mic Level:Direct Level) #
Mic:Adjust the volume of the microphone.
Dir:Adjust the volume of the direct sound.
Level (Output Level) #
Adjust the output level.
53:OVERDRIVE 2
This is an overdrive that provides heavy distortion.
fig.2-63
L in
Amp
Overdrive
Simulator
R in
Drive #
Adjust the amount of distortion. The volume will change
together with the degree of distortion.
Level (Output Level)
Adjust the output level.
LowGain
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi Gain
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Amp Type (Amp Simulator Switch/Type)
Turns the Amp Simulator on/off.
And djust the type of guitar amp.
SMALL : small amp
BUILT-IN : single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
L out
Pan L
2-Band
EQ
Pan R
R out
65