Roland XV-3080 Owner's Manual page 33

Cutoff Freq (Cutoff Frequency) *1
This sets the cutoff frequency at which the LPF or HPF begin
to work.
* 1 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000,
2500, 3150, 4000, 5000, 6300, 8000 Hz
For Delay
Delay C (Delay Center) 200–1000 ms
This sets the delay time for the delay located at the center of
the stereo field.
Delay L (Delay Left) 200–1000 ms
This sets the delay time for the delay located at the left side of
the stereo field.
Delay R (Delay Right) 200–1000 ms
This sets the delay time for the delay located at the right side
of the stereo field.
Fbk (Feedback) -98– +98%
This adjusts the amount of delay feedback, controlling the
number of times the delay repeats. Higher values result in
more repeats. With negative (-) values, the phase of the
repeated delays is inverted.
Level C (Delay Center Level) 0–127
This sets the volume level of the delay located at the center of
the stereo field.
Level L (Delay Left Level) 0–127
This sets the volume level of the delay located at the left side
of the stereo field.
Level R (Delay Right Level) 0–127
This sets the volume level of the delay located at the right
side of the stereo field.
HF Damp *1
This allows you to reduce, or "damp," the high-frequency
content of the repeated feedback delays – frequencies above
the selected value will be damped. If you do not wish to
damp the high-frequency content of the feedback delays, set
this parameter to BYPASS.
* 1 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000,
2500, 3150, 4000, 5000, 6300, 8000 Hz, BYPASS
RHYTHM CHO OUT (Rhythm Chorus
Output)
Output Assign (Chorus Output Assign) A/B/C
This setting selects the pair of OUTPUT jacks to which the
Chapter 2 Using the XV-3080 Effects
Chorus unit's stereo output is routed when Chorus Output
Select is set to "MAIN" or "MAIN+R."
Level (Chorus Level) 0–127
This setting determines the Chorus output level.
Select (Chorus Output Select)
This parameter allows you to send the Chorus output
directly to the currently selected OUTPUT jacks, to the
Reverb, or to both.
MAIN: The Chorus output is sent only to the OUTPUT jacks.
fig.2-03x.e
REV: The Chorus output is sent only to the Reverb.
fig.2-03y.e
Chorus Input
Chorus
MAIN+R: The Chorus output is sent to the OUTPUT jacks
and to the Reverb.
fig.2-03z.e
Chorus Input
Chorus
Reverb Input
Reverb
OUTPUT
Reverb OUTPUT
OUTPUT
OUTPUT
33