Roland XV-3080 Owner's Manual page 49

into the effect. Negative (-) settings will invert the phase.
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Balance (Effect Balance) #
Adjust the volume balance between the direct sound and the
delay sound. With a setting of D100:0W only the direct sound
will be output, and with a setting of D0:100W only the delay
sound will be output.
Level (Output Level)
Adjust the output level.
21: TIME CONTROL DELAY
This effect allows you to use a specified controller (the
controller selected in EFX Control Source) to control the
delay time and pitch in realtime. Lengthening the delay will
lower the pitch, and shortening it will raise the pitch.
For details refer to "Changing the Multi-Effects Settings
From an External MIDI Device (p. 135)."
fig.2-27
L in
Balance D
Time Control Delay
Feedback
R in
Balance D
Delay (Delay time) #
Adjust the time delay from the direct sound until when each
delay sound is heard.
Accel (Acceleration)
This parameter adjusts the time over which the Delay Time
will change from the current setting to a newly specified
setting. The rate of change for the Delay Time directly affects
the rate of pitch change.
Fbk (Feedback Level) #
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Pan (Output Pan)
Adjust the stereo location of the delay sound. L64 is far left, 0
is center, and 63R is far right.
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Chapter 2 Using the XV-3080 Effects
LowGain
Adjust the gain of the low frequency range.
Hi Gain
Adjust the gain of the high frequency range.
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
delay sound. With a setting of D100:0W only the direct sound
will be output, and with a setting of D0:100W only the delay
sound will be output.
Level (Output Level)
Adjust the output level.
49