Roland XV-3080 Owner's Manual page 19

In Performance mode
1. Press [PERFORM] to make its indicator light.
2. Set the transmission channel on the external MIDI device
to match the Performance Ctrl Ch(p. 131) setting on the
XV-3080.
To learn about the MIDI settings of your external MIDI
device, see its owner's manual.
3. Transmit the appropriate Bank Select MSB (Controller
#0) value to the XV-3080.
4. Transmit the appropriate Bank Select LSB (Controller
#32) value to the XV-3080.
5. Transmit the Program Change message value
corresponding to the Performance.
The desired Performance will be selected.
* When the XV-3080 receives a Program Change message
without Bank Select messages, the corresponding Performance
in the currently selected group or bank will be chosen.
You can select any Performance Part's Patch or Rhythm Set
via MIDI. To learn how, refer to "Assigning a different Patch
to Part (P. 25)" in the XV-3080 QUICK START.
The Performances in each group correspond to the Bank
Select numbers as follows.
Performance
PerformancePerformance
group number
USER 001–064
PR-A 001–032
PR-B 001–032
CD-A 001–064
: :
CD-H 001–064
* When Patch/Rhy Rx Ch and Perform Ctrl Ch are set to the
same channel, both Bank Select and Program Change are sent,
making it possible to switch among Patches, Rhythm Sets, and
Performances.
Bank Select Number Program
MSB LSB number
85 00 001–064
85 64 001–032
85 65 001–032
85 32 001–064
: : :
85 39 001–064
Chapter 1 Selecting and Playing a Sound
Using MIDI to Switch between Patch,
Performance and General MIDI 2
Modes
You can switch between Patch, Performance, and General
MIDI 2 modes by transmitting the appropriate System
Exclusive (Sys Ex) message to the XV-3080, as listed below.
(Sys Ex messages are constructed using hexadecimal
notation.)
Sys Ex message for switching to Patch mode
F0 41 10 00 10 12 00 00 00 00 01 7F F7
Sys Ex message for switching to Performance
mode
F0 41 10 00 10 12 00 00 00 00 00 00 F7
Sys Ex message for switching to General MIDI
2 mode
F0 41 10 00 10 12 00 00 00 00 03 7F F7
* The third byte of the MIDI message indicates the device ID
number, and the factory setting is "10". (This is "10" in
hexadecimal notation; in decimal this would be 16.) (This
device ID number will appear as 17 in the display of the XV-
3080. The transmitted messages will use a value of one less
than this (16).) If you have modified the device ID number (p.
132), modify the third byte to the appropriate value when
transmitting the above exclusive message.
19