Selecting The Output Device (Output Select); Turning Off The Guitar Amp Simulator (G.amp Sim) - Roland GR-33 Owner's Manual

fig.1-12

Selecting the output device (OUTPUT SELECT)

In order for the GR-33 to produce the correct output levels,
you must select the type of device to which its outputs are
connected (MIX OUT).
fig.1-14
1. Press [OUTPUT SELECT] and select the appropriate
setting.
The currently selected setting will light.
• GUITAR AMP:
Select this when using a dedicated guitar amp.
• LINE:
Select this when using a keyboard amp, general-purpose
instrument amp, mixer, MTR, or headphones.
The GR-33's sound generator is a PCM synthesizer that can
reproduce a wide range of timbres. To optimally capture its
rich synthesizer sounds, use a keyboard amp, other general
instrument amplifier, PA system, or other such equipment
instead of a guitar amplifier if possible.
* Changing the OUTPUT SELECT setting will not affect the
settings that are stored in each patch.
5. Tune each of the other strings, 5 to 1, to A, D, G, B, and
too high
6. When you are finished tuning, press any foot pedal,
Just Tuned
too low
Turning off the guitar amp
simulator (G.AMP SIM)
The GR-33 has a built-in guitar amp simulator (G.AMP SIM).
If OUTPUT SELECT is set to "LINE," the guitar amp
simulator will be applied only to the guitar sound itself. This
allows you to create the illusion of the original guitar sound
being played through a guitar amp, even when it is being fed
directly into another device.
If you are not using the GR-33's internal guitar amp
simulator—if you are using an external amp simulator effect
device, for example—set the GR-33 as follows.
1. Press [SYSTEM] to enter System mode.
2. Press [PARAMETER] to select "G.AMP SIM"
fig.1-15
3. Turn [VALUE] to select "Off."
4. Press [PLAY] to return to Play mode.
Chapter 1 Producing Sounds
E, respectively.
[S1] or [S2] on the GK-2A, or [PLAY], to return to Play
mode.
Turning the Amp Simulator Off
• Off:
The amp simulator will not be used.
• On:
The amp simulator will be used when OUTPUT SELECT
is set to "LINE."
* When you once again wish to use the amp simulator, select
"On" in Step 3.
19