Chapter 9 Examples Of Applications Using The Xv-3080; Controlling The Xv-3080 In Realtime With An External Midi Device; Changing The Multi-Effects Settings From An External Midi Device; Modifying Tone Settings - Roland XV-3080 Owner's Manual

Chapter 9 Examples of Applications
Using the XV-3080
Controlling the XV-3080 in
Realtime With an External
MIDI Device
External MIDI controllers (modulation lever, foot switch,
expression pedal etc.) can be used to modify Multi-Effects
settings or Tone settings in realtime.
Changing the Multi-Effects
Settings From an External MIDI
Device
The parameters that can be changed via MIDI are
predetermined according to the selected Multi-Effects (MFX)
Type.
This applies to the MFX Type parameters described in pages
36 to 70 that have an appended "#" mark.
1. Select the Patch or Performance you wish to use.
2. Press [EFFECTS] to make its indicator light.
3. Press [
] / [ ] to select the MFX TYPE page, and
select the type of Multi-Effect you wish to use.
In a Performance, you can select the Multi-Effects for a Part
using the Source parameter.
4. Use [
] / [ ] to select the PATCH MFX CTRL page
for a Patch, or select the PERFORM MFX CTRL page for
a Performance Part.
* You cannot select these pages when the Type is set to
"THROUGH."
5. Press [
] / [ ] to move the cursor to the
parameter that you wish to adjust.
6. Turn the VALUE dial or press [INC] / [DEC] to select the
desired value.
PATCH MFX CTRL (Patch MFX Control)
Control 1–4 (MFX Control 1–4 Source)
OFF: No controller is used.
CC01–95: Controller numbers 1–95 (except for 32)
BENDER: Pitch Bend
AFTERTOUCH: Aftertouch
SYS-CTRL 1–4: System control (Control 1–4)
Destination
This selects the Multi-Effects parameter to be controlled
using the MFX Control 1–4 source.
Sens (MFX Control Sens) -63– +63
If you wish to modify the selected parameter in a positive (+)
direction – i.e., a higher value, toward the right, or faster etc.
– from its current setting, select a positive (+) value. If you
wish to modify the selected parameter in a negative (-)
direction – i.e., a lower value, toward the left, or slower etc. –
from its current setting, select a negative (-) value. Higher
numbers produce a greater amount of change.

Modifying Tone Settings

You can use the Matrix Control parameter to control Tone
settings in realtime.
Selecting the MIDI Messages Used for
Control and the Parameters to Be
Changed
1. Select the Patch you wish to use.
2. Press [CONTROL] to make its indicator light.
3. Press [
] / [ ] to select the MATRIX CTRL SRC page.
4. Turn the VALUE dial or press [INC] / [DEC] to set
Control 1–4.
5. Press [
] / [ ] to select the MATRIX CONTROL page
containing the control source destination you want to set.
6. Press [
] / [ ] to move the cursor to the
parameter you wish to set.
7. Turn the VALUE dial or press [INC] / [DEC] to specify
the parameter to be controlled (Dest), the control
sensitivity (Sns) and the desired Tone (Tone).
135