Table of Contents
Advertisement
Delay L (Delay Time Left)
Adjust the delay time from the original sound until the left
delay sound is heard.
Delay R (Delay Time Right)
Adjust the delay time from the original sound until the right
delay sound is heard.
Fbk (Feedback) #
Adjust the proportion (%) of the delay sound that is to be
returned to the input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase.
Level C (Level Center)
Adjust the volume of the left delay sound.
Level L (Level Left)
Adjust the volume of the center delay sound.
Level R (Level Right)
Adjust the volume of the right delay sound.
HF Damp
Adjust the frequency above which delayed sound fed back to
the delay input will be cut.
If you do not want to cut the high frequencies of the
feedback, set this parameter to BYPASS.
Out (Output Mode)
Adjust the method that will be used to hear the sound that is
output to the OUTPUT jacks. The optimal 3D effect will be
achieved if you select Speaker when using speakers, or
Phones when using headphones.
Lo G (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi G (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance (Effect Balance) #
Sets the volume balance between the source sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Chapter 2 Using the XV-3080 Effects
Lev (Output Level)
Adjust the output level.
49:3VOICE PITCH SHIFTER
A Pitch Shifter shifts the pitch of the original sound. This 3-
voice pitch shifter has three pitch shifters, and can add three
pitch shifted sounds to the original sound.
fig.2-58
L
Pitch 1
Pitch 2
Pitch 3
R
Coarse 1:2:3 (Coarse Pitch 1:2:3)
Specify the pitch in semitones for pitch shift 1–3.
Fine 1:2:3 (Fine Pitch 1:2:3)
Make fine adjustments to the pitch of the pitch shift 1–3 in 2-
cent steps.
Pre Delay 1:2:3 (Pre Delay Time 1:2:3)
Specify the time delay from the original sound until the pitch
shift 1–3 sound is heard.
Fbk 1:2:3 (Feedback Level 1:2:3)
Adjust the proportion (%) of the pitch shift 1–3 sound that is
fed back into the effect.
Pan 1:2:3 (Output Pan 1:2:3)
Specify the stereo location of the pitch shift 1–3 sound. L64 is
far left, 0 is center, and 63R is far right.
Level 1:2:3 (Level 1:2:3)
Specify the volume of the pitch shift 1--3.
Balance (Effect Balance)
Sets the volume balance between the source sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W the effect sound will
be output.
L out
1
2
3
R out
63
Advertisement
Table of Contents
