Table of Contents
Advertisement
16 Installation
TM-2000/MTM-2000 Software Installation Configuration Options
NOTE:
A keyboard and a monitor connected to an external PC connected to the TM-2000/MTM-2000 is required to
perform the software installation.
When the option to install the software is selected, the computer prompts for different pieces of information:
"Is the computer to be part of an active/standby configuration?"
There are three (3) choices:
Stand-alone operation -
Active/standby operation
(Standby by default) -
Active/standby
(Standby by default) -
In addition the following parameters are set by default:
Domain or Workgroup Name:
Network Number:
Subnet Mask:
Broadcast Address:
When installing the software, it attempts to determine the hard disk drive size and partition information. You have two (2)
choices:
The user has control on how the hard disk is partitioned.
•
The software generates the partitions.
•
If the default partitioning is chosen, two (2) partitions are generated: one (1) at 5MB (containing
essential boot files) and one (1) at 250MB.
Bosch Security Systems, Inc.
This option sets the computer name to tm_solo; the IP Address to 10.201.202.203; and no
standby computer.
This option sets the computer name to tm1; the IP Address to 10.201.202.204; and the
active/standby computer to tm2/10.201.202.205.
This option sets the computer name to tm2; the IP Address to 10.201.202.205; and the
active/standby computer to tm1/10.201.202.204.
WORKGROUP This is significant if you want to access the TM-2000's hard disk from a
Windows machine.
10.0.0.0. This value may need to change if the IP Address is set to the something other
than 10.x.x.x.
255.0.0.0. This value may need to change if the network number is different.
10.255.255.255. This value may need to change if the network number is different.
User Manual
TM-2000 & MTM-2000 User Manual
F.01U.193.264
Rev. 12
Advertisement
Table of Contents
