Compressor - Roland MC-909 Owner's Manual

Parameter Range
7.
0–127
MFX1 Reverb
Send Level
8.
DRY, MFX2
MFX1 Output
Assign
9.
See "Multi-Ef-
(MFX Type) fects List" (p.
92)
10.
0–127
MFX2 Reverb
Send Level
11.
See "Reverb"
(Reverb Type) (p. 90)
If you change the "Output Assign" setting, the routing connections
in the screen will also change.
Parameters 4–11 in the above table are linked with the identically
named parameters in the setting screens of each effect.
Explanation
Depth of reverb applied to the
sound processed through
multi-effects 1
Set this to 0 if you don't
want to apply reverb.
Output destination of the
sound processed through
multi-effects 1
DRY: MIX OUTPUT jacks
MFX2: Multi-effects 2
(multi-effects 1 and 2 will be
connected in series)
The effect used by multi-ef-
fects 2
* For details on each effect,
refer to "Multi-Effects List"
(p. 92).
Depth of reverb applied to the
sound processed through
multi-effects 2
Set this to 0 if you don't
want to apply reverb.
The type of reverb
* For details on reverb, refer
to "Reverb" (p. 90).

Compressor

The compressor is an effect that limits the level of loud sounds and
boosts the level of soft sounds, making the overall level more
consistent.
fig.4-03
Parameter Range
Comp Reverb 0–127
Send Level
Comp Output DRY, MFX1,
Assign MFX2
Attack Time 0.05–50 ms
Release Time 0.05–2000 ms
Threshold 0–127
Ratio 1:1–inf:1
Output Gain 0– +24 dB
Low Freq 200, 400 Hz
Low Gain -15– +15
High Freq 2k, 4k, 8kHz
High Gain -15– +15
Level 0–127
Effects
Explanation
Depth of reverb applied to the
sound processed through the
compressor
Set this to 0 if you don't
want to apply reverb.
Output destination of the
sound processed through the
compressor
DRY: MIX OUTPUT jacks
MFX1 (2): Multi-effects 1
(or 2)
Time from when the volume
goes up the threshold level
until the compressor effect ap-
plies
Time from when the volume
falls below the threshold level
until the compressor effect no
longer applies
Volume level at which com-
pression begins
Compression ratio (inf: infini-
ty)
Level of the output sound
Reference frequency of the
low range
Amount of low-range boost/
cut
Reference frequency of the
high range
Amount of high-range boost/
cut
Output volume of the com-
pressor
89