Roland MC-909 Owner's Manual page 68

Patch Edit
CTRL1
These parameters let you specify the operation and result of various controllers.
Parameter Value
MATRIX CTRL #
This selects the parameters to be controlled by Matrix Control Source 1–4 and the Sens settings, as well as the specific Tones whose parameters
you wish to control. Up to four destination parameters can be selected for each controller and controlled simultaneously.
CTRL1 Destination 1–4 OFF, PCH, CUT, RES, LEV, PAN,
(Matrix Control 1 DRY, CHO, REV, PIT-LFO1(2),
Destination 1–4) TVF-LFO1(2), TVA-LFO1(2),
PAN-LFO1(2), LFO1(2)-RATE,
PIT-ATK, PIT-DCY, PIT-REL,
TVF-ATK, TVF-DCY, TVF-REL,
TVA-ATK, TVA-DCY, TVA-REL,
TMT, FXM, MFX-CTRL1–4
CTRL1 Sens 1–4 -63– +63
(Matrix Control 1 Sens
1–4)
CTRL1 Switch 1–4 OFF, ON, REVS
(Matrix Control 1 Tone
Control Switch 1–4)
General
Various other parameters are provided here.
Parameter Value
Patch Priority LAST,
LOUDEST
Tone Env Mode NSUS, SUST
(Tone Envelope
Mode)
68
Description
Parameter to be controlled
Range of change obtained through operating the controller
Negative (-) values will invert the change. If you set LFO depth to a nega-
tive value, the phase will be inverted. Setting LFO rate to a negative value
will lengthen the cycle, and setting it to a positive value will shorten the cy-
cle.
Tones to which the preceding two parameter settings will apply
The settings will apply to tones for which this is turned "ON." The effect
will be inverted for tones that are set to "REVS."
Description
Specifies what will happen if the maximum polyphony (64 voices) is exceeded
LAST: Voices played most recently will be given priority, while currently sounding voices will be
successively turned off, beginning with the oldest one.
LOUDEST: Voices of the loudest volume will be given priority, while currently sounding voices will
be successively turned off, beginning with the one with the lowest volume.
Specifies how notes will continue to sound while you hold down the key
NSUS (NO-SUSTAIN): The sound will decay naturally even if you continue to hold down the pad.
SUST (SUSTAIN): The sound will be sustained as long as you hold down the pad.
* If you have selected a one-shot waveform, the sound will not be sustained even if you select "SUST."