Space-D - Roland MC-909 Owner's Manual

19: SPACE-D

This is a multiple chorus that applies two-phase modulation in
stereo. It creates no audible modulation, yet produces a transparent
chorus effect.
fig.MFX19
Balance D
L in
Space D
Space D
R in
Balance D
Parameter Value Description
Pre Delay 0.0–100.0 Adjusts the time until the chorus
ms sound is heard.
Rate #1 0.05–10.00 Frequency of modulation
Hz
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Low Gain -15– +15 dB Gain of the low frequency range
High Gain -15– +15 dB Gain of the high frequency range
Balance #2 D100:0W– Volume balance between the direct
D0:100W sound (D) and the chorus sound
(W)
Level 0–127 Output level
20: STEREO CHORUS
This is a stereo chorus. A filter is provided so that you can adjust the
timbre of the chorused sound.
fig.MFX20
Balance D
L in
Chorus
Chorus
R in
Balance D
Parameter Value Description
Filter Type OFF, LPF, Type of filter
HPF
Cutoff Freq 200–8000 Basic frequency of the filter
Hz
Pre Delay 0.0–100.0 Adjusts the time until the chorus
ms sound is heard.
Rate #1 0.05–10.00 Frequency of modulation
Hz
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Low Gain -15– +15 dB Gain of the low frequency range
High Gain -15– +15 dB Gain of the high frequency range
Balance #2 D100:0W– Volume balance between the direct
D0:100W sound (D) and the chorus sound
(W)
Level 0–127 Output level
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
OFF: no filter is used
LPF: cuts the frequency range
above the Cutoff Freq
HPF: cuts the frequency range
below the Cutoff Freq
21: STEREO FLANGER
This is a stereo flanger. It produces a metallic resonance that rises
and falls somewhat like a jet airplane taking off or landing. A filter is
provided so that you can adjust the timbre of the flanged sound.
fig.MFX21
Balance D
L in
Flanger
Feedback
Feedback
Flanger
R in
Balance D
Parameter Value Description
Filter Type OFF, LPF, Type of filter
HPF
Cutoff Freq 200–8000 Basic frequency of the filter
Hz
Pre Delay 0.0–100.0 Adjusts the time until the flanger
ms sound is heard.
Rate #1 0.05-10.00 Frequency of modulation
Hz, note
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Feedback -98– +98 % Adjusts the amount of the flanger
#2 sound that's fed back into the effect.
Negative (-) settings invert the
phase.
Low Gain -15– +15 dB Gain of the low frequency range
High Gain -15– +15 dB Gain of the high frequency range
Balance D100:0W– Volume balance between the direct
D0:100W sound (D) and the flanger sound
(W)
Level 0–127 Output level
Multi-Effects List
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
OFF: no filter is used
LPF: cuts the frequency range
above the Cutoff Freq
HPF: cuts the frequency range
below the Cutoff Freq
97