Roland JUNO-D Owner's Manual page 104

Troubleshooting
Cannot play phrase/arpeggios
Is the MIDI clock not being received when
Clock Source (p. 89) is set to MIDI?
Set the system so that the MIDI clock is received from the
external MIDI device. Certain MIDI devices you may have
connected may not send the MIDI clock to the JUNO-D except
during recording or playback.
Sound does not stop when key
is pressed
Is the Hold Pedal Polarity reversed? (p. 89)
MIDI messages not received
correctly
Are the Patch Receive channel settings correct?
(p. 90).
Is each Receive switch set correctly?
Check the Performance Control Channel (p. 90), Receive
Program Change switch (p. 90), Receive Bank Select switch (p.
90), Receive System Exclusive switch (p. 90) settings.
Are Device ID number settings correct?
Set the Device ID number (p. 91) used when the Exclusive
message was recorded to the sequencer.
Is the sequencer playback tempo correct?
Play back the data on the sequencer at the tempo used when the
Exclusive message was recorded to the sequencer.
MIDI messages not transmitted
correctly
Are the Patch transmission channel settings
correct? (p. 95)
Is each Transmission switch set correctly?
Check the Transmit Program Change switch (p. 90), Transmit
Bank Select switch (p. 90), Transmit Edit Data switch (p. 91),
Transmit Active Sensing switch (p. 91) settings.
104
Using sequencer software,
modulation lever and knob
movements have no effect on
the sound
Some types of sequencer software may not allow Soft Thru (i.e., data
received at the MIDI IN connector is not sent from the MIDI OUT
connector as is) for Exclusive messages. When recording Exclusive
messages with such sequencer software, set Local Control to ON (p.
89).