Blackmagicdesign ATEM Installation And Operation Manual page 151

Routing the Aux Output using ATEM Software Control
ATEM Software Control has an auxiliary output setting in the menu bar at the top of the screen.
All you need to do is click on the 'auxiliary 1' setting and scroll through the drop down list to
select the source you want to output. When selected, the auxiliary output will change
immediately. You can see the currently selected source with a tick in the menu item.
List of Auxiliary Output Sources)
Routing the Aux Output using an ATEM Hardware Panel
On ATEM broadcast panels, you can route the auxiliary output using the auxiliary settings in the
system control menu. To do this:
1 Press the 'aux' button in the system control 'home' menu to open the auxiliary menu.
2 In the auxiliary menu, select auxiliary 1.
3 Press a source button on the corresponding M/E's source select row. Depending on
the panel you are using, you may need to hold the shift button down to access your
desired source.
4 Press the 'home' system control button to return to the home menu.
TIP If you are switching using the second M/E panel on an ATEM 2 M/E Broadcast
Panel, you can use the dedicated auxiliary crosspoint buttons on the M/E 2
destination bus.
To use the auxiliary crosspoint buttons on M/E 2:
1 Press the 'auxiliary 1' button in the destination bus to select the auxiliary
destination.
2 Now press the desired source button in the source select row, located
underneath the destination row.
Using the Auxiliary Output 151