Button Mapping - Blackmagicdesign ATEM Installation And Operation Manual

To change the language:
1
Go to the menu bar at the top of your screen, select 'ATEM Software Control' and open
the 'preferences'.
2 Select your desired language from the drop down menu in the 'Software Control
Language' in general settings.
A warning will appear asking you to confirm the action. Click 'change'.
ATEM Software control will now close and restart in your selected language.
You can change the language for ATEM Software
Control in the ATEM Software Control preferences.

Button Mapping

In the mapping preferences, you can assign inputs to specific buttons on the preview and
program rows. The camera drop down menu lets you select a 'Blackmagic SDI' camera for each
input, or you can select 'none' if you don't have a camera connected to the input.
ATEM software and hardware control panels support button mapping so you can assign your
most important sources, especially cameras, to the most accessible buttons in the program and
preview rows. Occasional sources can be assigned to less prominent buttons. Button mapping
is set independently for each control panel so button mapping set on a software control panel
will not affect the button mapping set on a hardware control panel.
You can assign a camera from the 'camera' drop down menu
Using ATEM Software Control 30