Martin Atomic 3000 LED Service Manual page 17

Service manual
6. Press the UP arrow and select PROCEED.
7. Scroll down to PSU CALIBRATION and press the
button in the middle.
8. Change each digit according to the digits in the
calibration code. See figure 14 on page 17.
9. Press the MENU button.
10. Use the UP/DOWN button to select the correct
value.
11. Press the MENU button to confirm the selection
12. Press the LEFT button to confirm your change.
13. Follow step 9 to 12 until you have changed all the
digits in the calibration code.
14. Exit the menu by continuously pressing the LEFT
button.
Atomic 3000 LED - Revision A, 11-30-2017
Figure 36: Selecting PROCEED
Figure 38: Selecting PSU CALIBRATION
Figure 37: Changing the digits in the code
17 of 20