GEN
INFO
4. Check that the control lever 1 comes in
contact with the adjusting screw 4.
NOTE:
To adjust the throttle cable, refer to page 3-7.
5. Set the remote control lever is in "N" posi-
tion, and then check that the mark a on
the bracket 5 is aligned with the mark b
on the shift lever 6.
6
b
a
6. Check that the screwed length of the shift
/ throttle cable joint 7 .
7
w
The shift / throttle cable joint 7 must be
screwed in a minimum of 8.0 mm (0.31 in)
c.
1-15
General information
1
4
68810060
5
68810070
c
6D430227
Checking the steering system
1. Check that the steering operates smooth-
ly.
2. Check that there is no interference with
wires or hoses when the outboard motor
is steered.
Checking the PTT system
(ET)
1. Check that the outboard motor tilts up
and down smoothly when operating the
PTT unit.
2. Check that there is no abnormal noise
produced when the outboard motor is tilt-
ed up or down.
3. Check that there is no interference with
wires or hoses when the tilted up out-
board motor is steered.
4. Check that the trim meter points down
when the outboard motor is tilted all the
way down.
68810090
68810100
6885J11