Assembling The Swivel Bracket (Et); Installing The Clamp Bracket (Et); Installing The Ptt Unit (Et) - Yamaha 55DEHD Service Manual

Assembling the swivel bracket (ET)

NOTE:
To assemble the swivel bracket, refer to page
7-24.

Installing the clamp bracket (ET)

1. Install the trim sensor 1, and then tight-
en the screws 2.
1
2. Install the bushings 3 into the swivel
bracket 4, then install the swivel bracket
4, washers 5, clamp brackets 6, and
through tube 7.
5 3
8
6
7
NOTE:
Adjust the trim sensor cam after installing the
PTT, refer to page 7-33.
3. Install the self-locking nut 8 temporarily.
4. Install the ground lead between the
clamp brackets and the swivel bracket.
6885J11
2
68870450
4
5
3
6
68870460
Clamp bracket and swivel bracket

Installing the PTT unit (ET)

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
1
w
9 When installing the PTT unit without
removing the power unit, be sure to sus-
pend the outboard motor. Otherwise, the
outboard motor could suddenly fall and
result in injury.
9 After tilting the outboard motor up, be
sure to support it with the tilt stop lever.
2. Install the bushing 2 and 3.
3. Lift the PTT unit 4 up and install the PTT
unit mounting bolts 5, and then tighten
them.
4. Install the tilt ram upper end into the swiv-
el bracket with the pin 6 and circlip 7.
6
5
68870475
2
2 3 3
7
5
4
68870485
7-32
1
2
3
4
5
6
7
8
9