Electrical Connection - Cafection Encore lite Service & Installation Manual

4.8

Electrical Connection

This equipment must be installed in compliance with applicable federal, state,
provincial and/or municipal electrical codes having jurisdiction.
1. Locate the unit's power cord and remove it from its transport socket. Discard the transport
The transport water tank safety part keeps the float out from moving during
transport. The water tank will not fill if this part is not removed.
2. Make sure the power switch at the back of the unit is in the OFF position before plugging in the
3. Access the back of the brewer and toggle the power switch to the ON position. Water will
4. Once the tank is full, water will take 10 to 20 minutes to heat to brewing temperature.
5. Once the coffee machine is ready, the selection screen will appear.
ALWAYS unplug the main power cord from the power outlet (AC line voltage) when
servicing any electrical component on the equipment.
24
SERVICE & INSTALLATION MANUAL for Cafection's Encore Lite
Make sure:
- The equipment is OFF before plugging it in.
- The equipment has its own electrical outlet.
- NO extension cord is used.
water tank safety part (recyclable).
unit into its own grounded electrical outlet.
automatically enter the brewer. The filling cycle should take a maximum of 2 to 3 minutes.
OFF position
www.cafection.com 800-561-6162
Transport water
tank safety part
ENCORE LITE Rev. 3 05/2018