OKIDATA Microline 395 Service Handbook page 97

%3.5 Lubrication
3.5 LUBRICATION
3.5.01 General Information
When lubricating the printer, refer to the lubrication diagrams on the following pages. Each lubrication
point lists a code for the type of lubricant to be used along with a code for the amount of lubricant
required. These codes are defined below.
Lubrication Interval
Once a year or every 600 hours of operation
Recommended Lubricant
Machine Oil : 10w-30 or equivalent (shown as PM on lubrication diagrams)
Moly-grease: Alvania grease #2 EP or equivalent (shown as GEP on lubrication diagrams)
Lubricant Amounts
Apply Abundantly: (shown as A on lubrication diagrams)
3-4 Drops of Oil / .008 inches of Grease: (shown as B on lubrication diagrams)
One drop of Oil: (shown as C on lubrication diagrams)
CAUTION:
Do not allow lubricant to contact the following areas.
Sensors
Platen (rubber face)
Printhead
Mini-pitch belt
Space belt
Ribbon
Tractor Pins
ML395 ( 96-02-03 )