OKIDATA Microline 395 Service Handbook page 30

Table of Contents

Advertisement

%2.2.05 Paper-End Detection
2.2.05 Paper-End Detection
Cut-Sheet Paper-End
When the release lever is in the SHEET FEED position, the photosensor located in the paper pressure
guide is active. If sheet paper is installed, the paper is detected by the sensor and the sensor is turned
on. When the printer is out of sheet paper, the sensor is turned off indicating a paper-end condition.
Bottom Feed Paper-End
(Used with optional Pull Tractor)
When the release lever is in the TRACTOR FEED position, the switch on the left push tractor and the
paper-end sensor on the sensor board are active. If paper is detected by either of these sensors,
paper-end is inhibited.
When bottom feed paper is installed, it moves the bottom paper-end lever to turn the sensor ON. When a
paper out condition exists, the lever blocks the sensor indicating a paper-end condition.
Rear Feed Paper-End
When the release lever is in the TRACTOR FEED position, the switch on the left push tractor and the
paper-end sensor on the sensor board are active. If paper is detected by either of these sensors,
paper-end is inhibited.
When rear feed paper is installed, pressure is placed on the microswitch, located in the left push tractor.
ML395 ( 96-02-03 )

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Microline 395c

Table of Contents