OKIDATA Microline 395 Service Handbook page 56

%3.2.17 Bail/Ribbon Motor Assembly
3.2.17 Bail/Ribbon Motor Assembly
1. Remove the printer mechanism (3.2.09).
2. Disconnect connector CN2 (1).
3. Remove the two mounting screws (2).
4. Detach the bail/ribbon motor assembly (3).
NOTE:
When assembling, install the bail/ribbon motor assembly so that the gear teeth contact properly. The
gears must not bind together.
P/N 56506301 Motor: Step (Bail Arm) Assembly RSPL B.2.06, 09
ML395 ( 96-02-03 )