Managing; The Management Gui - Dell EMC ML3 User Manual

Managing

Certain user roles can perform different functions.
v The Admin role has access to all menus except those menus that are restricted to Service only. The
default password is adm001.The Admin account has access to monitor, configure, and run unit
diagnostics (only exception is the advanced diagnostic procedures that are reserved for service
personnel only).
v Superuser - The Superuser role has access to most sections. The default password is sup001.
v Monitor - Normal user level - The Monitor role has viewing privileges to the unit, but is not able to
make configuration changes.
v Service - Service personnel user level - Access to this level is for Service personnel only. Service
personnel have access to all menus. The Service account has all the same privileges as the Admin
account with the addition of advanced unit diagnostic procedures.
Note: User and Superuser accounts must be enabled by the library administrator. These accounts are
disabled by default.

The Management GUI

With the Management Graphical User Interface (GUI), you can monitor, configure, and operate most
library functions from a web browser.
When possible, it is recommended that the Management GUI be used as the primary library interface.
The web interface provides access to more features, includes online help, and is easier to use.
Before the Management GUI can be used, you must log in and configure the library network settings
with the Operator Panel. This action can be done during Initial Setup. See "The Initial Setup process" on
page 52.
Logging in with the Management GUI
1. Open a supported web browser and enter the IP address of the library in the browser's address bar.
2. Select the user level and enter the password. Click Login.The ML3 RMU screen shows Welcome: User,
superuser, admin, or service after a successful login. The user can log out at any time by clicking the
"logout" text in the upper right corner of the RMU page.
Note: For initial login, select Adminstrator and the password is adm001.
Note: Only one person (on Operator Panel or Management GUI) can be logged in to the library at a time.
Any time that you try to log in and another person is already logged in, a dialog box appears, asking if
you want to log off the other user.
The Library main screen on the Management GUI
The library main screen is organized into the following regions:
59