Half-Height Fc Single Port; Full-Height Fc Dual Port - Dell EMC ML3 User Manual

1. Remove the FC port caps if necessary. Attach one end of the FC cable to port 0 on the tape drive.
Figure 49. Full-height FC dual port
Table 23. Full-height FC dual port
Number
1
2
3
Figure 50. Half-height FC single port
Table 24. Half-height FC single port
Number
1
2
2. Attach the other end of the FC cable to a switch or HBA.
3. Repeat the same process with port 1 if you have a dual port drive.
Connecting SAS cables
1. Attach the end of the SAS cable into the connector on the HBA. If you are using a SAS
fanout/Interposer cable, the end of the cable with only one connector must be plugged into the HBA.
2. Connect the drive end of the cable.
50
Dell EMC ML3 Tape Library: User's Guide
Description
FC port 0
FC port 1
Drive sled indicators (see Figure 18 on page 13)
Description
FC port 0
Drive sled indicators (see Figure 18 on page 13)