Dell EMC ML3 User Manual page 118

Parameter
Code Flag name
04d Library
Hardware D
05d Library
Diagnostics
Required
13d Library Pick
Retry
14d Library Place
Retry
15d Library Load
Retry
16d Library Door
17d Library I/O
Station
19d Library
Security
20d Library
Security Mode
21d Library Offline I
22d Library Drive
Offline
24d Library
Inventory
28d Power Supply
33d Library
Capacity
Exceeded
v I = Informational suggestion to user
v W = Warning. Remedial action is advised. Performance of data might be at risk.
v C = Critical immediate remedial action is required.
96
Dell EMC ML3 Tape Library: User's Guide
Type Description
C The library has a hardware fault that is not mechanically related or
requires a power cycle to recover.
v Turn the media changer OFF, then ON.
v Restart the operation.
v If the problem persists, contact Technical Support.
W The library mechanism might have a hardware fault.
Run extended diagnostics to verify and diagnose the problem. Check the
library user's manual for device-specific instructions on running extended
diagnostic tests.
W There is a potential problem with the drive ejecting cartridges or with the
library picking cartridges from a slot.
v No action needs to be taken at this time.
v If the problem persists, contact Technical Support.
W There is a potential problem with the library mechanism placing a
cartridge into a slot.
v No action needs to be taken at this time.
v If the problem persists, contact Technical Support.
W There is a potential problem with the drive or the library mechanism
loading cartridges, or an incompatible cartridge.
This flag is cleared when the next move command is received.
C The operation failed because the library door is open.
v Clear any obstructions from the library door.
v Close the library door.
v If the problem persists, call the library supplier help line.
C There is a mechanical problem with the library media I/O Station.
W Library security is compromised. The door was opened then closed
during operation.
I The library security mode was changed. The library was either put into
secure mode, or the library exited the secure mode. This is for
information purposes only. No action is required.
The library was manually turned offline and is unavailable for use.
I A drive inside the library was taken offline. This is for information
purposes only. No action is required.
C The library detected an inconsistency in its inventory.
v Redo the library inventory to correct inconsistency.
v Restart the operation.
W A redundant power supply failed inside the library. Check the library
users manual for instructions on replacing the failed power supply.
C The total number of volumes exceeds the available number of storage
elements. Remove a cartridge from the inventory to recover.