LOGICDATA COMPACT User Manual page 34

Code Description
36 Plug detection in M1 motor
socket
37 Plug detection in M2 motor
socket
38 Plug detection in M3 motor
socket
61 Actuator changed
55 Synchronization
group 1
56 Synchronization
group 2
67 High voltage
70 Motor configuration changed
71 Anti-Pinch
changed
81 Internal error
Danger: the PowerFail detection identifies mains power breakdowns
and saves all relevant data before the voltage falls below a critical
threshold.
In some exceptional cases this storage is not possible and the error E81
is shown on the handswitch display (if available) and the COMPACT
clicks three times.
To rectify this error, a manual reset is necessary (see page 20).
Remedy
Plug in the correct motor to the motor
socket that shows the error.
Reset all motors.
lost motor Remove load from desktop.
Reset all motors;
If error occurs after reset again, contact
lost motor
customer service
Unplug power cord and contact the
customer service.
See chapter 4.3.3
configuration See chapter 4.3.6 to activate or deactivate
the anti-pinch configuration
Make a manual reset.
Unplug power cord and plug it in again
after a few seconds.
If this error occurs frequently, unplug the
power cord and contact the customer
service.
Page 34 / 43