X19; X20 - LinMot E1450-PL-QN-0S Installation Manual

E1400 V2 Installation Guide

7.15 X19

X19 System
RJ-45 Use isolated USB-RS232 converter (Art.-No. 0150-2473 or 0150-3120) for configuration over RS232.

7.16 X20

X20 Analog In (+-10V Differential Analog Input)
RJ-45
7.17 S5
S5 Bus Termination / AnaIn2 Pull Down
S5
Page 16/27
1 Do not connect
2 Do not connect
3 RS232 Rx
4 GND
5 GND
6 RS232 Tx
7 Do not connect
8 Do not connect
case Shield
1 Do not connect
2 Do not connect
3 Analog In -
4 GND
5 GND
6 Analog In +
7 Do not connect
8 Do not connect
case Shield
Switch 6: Override Configuration Ethernet to DHCP
Switch 5: Bootstrap: Must be off for normal operation
Switch 4: CAN termination on ME (120R between pin 7 and 8 on X10/X11) on/off
Switch 3: CAN termination on CMD (120R between pin 7 and 8 on X7/X8) on/off
Switch 2: Termination resistor for RS485 on CMD (120R between pin 1 and 2 on X7/X8) on/off
Switch 1: AnIn2 pull down (4k7 Pull down on X4.4). Set to ON, if X4.4 is used as digital output.
Factory setting: all switches "on" except S5.5 (Bootstrap) and S5.6 (Override to DHCP)
www.LinMot.com NTI AG / LinMot ®