X33; X7 - X8 - LinMot E1450-PL-QN-0S Installation Manual

7.8 X33

X33
Spring cage connector
7.9 X7 – X8

X7 - X8

CMD (RS485/CAN)
RJ-45 Use twisted pair (1-2, 3-6, 4-5, 7-8) cable for wiring.
The built in RS485 and CAN terminations can be activated by S5.2 and S5.3.
X7 is internally connected to X8 (1:1 connection)
7.10 X9
X9 PROFIBUS DP (only available on E1430-DP-QN)
DSUB-9 (f) Max. Baud rate: 12Mbaud
NTI AG / LinMot
Safety Relays (only with the -1S option)
4 / 8 Ksr +
3 / 7 Ksr -
2 / 6 Ksr f+
1 / 5 Ksr f-
- Use 60/75°C copper conductors only
- Conductor cross-section max. 1.5mm 2 (AWG 16)
- Stripping length: 10mm
- Never connect the safety relays to the logic supply of the drive!
1 RS485_Rx+
2 RS485_Rx-
3 RS485_Tx+
4 GND
5 GND
6 RS485_Tx-
7 CAN_H
8 CAN_L
case Shield
1 Not connected
6 +5V
2 Not connected
7 Not connected
3 RxD/TxD-P
8 RxD/TxD-N
4 CNTR-P
9 Not connected
5 GND
case Shield
® www.LinMot.com
E1400 V2 Installation Guide
Safety Relay 1 / 2 Input positive
Safety Relay 1 / 2 Input negative
Safety Relay 1 / 2 feedback positive
Safety Relay 1 / 2 feedback negative
A
B
Y
Z
(isolated)
(isolated)
Page 13/27