Configuration Menu 1 - Ametek 7270 Instruction Manual

Chapter 5, FRONT PANEL OPERATION

5.3.15 Configuration Menu 1

5-28
AUTO DEFAULT
With an instrument of the design of the model 7270, where there are many controls
of which only a few are regularly adjusted, it is very easy to overlook the setting of
one of them. Consequently an Auto-Default function is provided, which sets all the
controls to a defined state. This is most often used as a rescue operation to bring the
instrument into a known condition when it is giving unexpected results. A listing of
the settings which are invoked by the use of this function can be found in
appendix D.
Pressing the Previous Menu key returns control to Main Menu 1
When Main Menu 1 is displayed, pressing a key adjacent to the Configuration item
accesses the Configuration Menu 1, which is shown in figure 5-19.
Figure 5-19, Configuration Menu 1, Single Reference Mode
The Configuration Menu 1 has four controls used to set the instrument's basic
operating mode, controls for the noise measurement mode, and a display of the
version of the instrument firmware. Changes to the setting of the controls can be
made by using the adjacent
It is also used to access the Communications, Options, and Configuration 2 menus.
The relationship of these menus to Main Menu 1 is shown in figure 5-20. Note that
as with the main menu structure, shown in figure 5-1, it is possible to return to the
Main Display from any menu by pressing the Main Display key, but this has been
omitted from figure 5-20 for the sake of clarity.
keys.