Ametek 7270 Instruction Manual page 212

Appendix E, ALPHABETICAL LISTING OF COMMANDS
SLOPE [n]
E-20
n full-scale sensitivity
IMODE=0
1 2 nV
2 5 nV
3 10 nV
4 20 nV
5 50 nV
6 100 nV
7 200 nV
8 500 nV
9 1 µV
10 2 µV
11 5 µV
12 10 µV
13 20 µV
14 50 µV
15 100 µV
16 200 µV
17 500 µV
18 1 mV
19 2 mV
20 5 mV
21 10 mV
22 20 mV
23 50 mV
24 100 mV
25 200 mV
26 500 mV
27 1 V
Floating point mode can only be used for reading the sensitivity, which is reported in
volts or amps. For example, if IMODE = 0 and the sensitivity is 1 mV the command
SEN would report 18 and the command SEN. would report +1.0E-03. If IMODE was
changed to 1, SEN would still report 18 but SEN. would report +1.0E-09
Output low-pass filter slope (roll-off) control
When the fast analog output mode and noise measurement mode are turned off
(FASTMODE 0 and NOISEMODE 0), the selection is according to the following
table:
n Slope
0 6 dB/octave
1 12 dB/octave
2 18 dB/octave
3 24 dB/octave
When:
a) The fast output filter mode is turned on, or
b) Noise measurement mode is turned ON (NOISEMODE 1)
the selection is according to the following table:
IMODE=1 IMODE=2
2 fA n/a
5 fA n/a
10 fA n/a
20 fA n/a
50 fA n/a
100 fA n/a
200 fA 2 fA
500 fA 5 fA
1 pA 10 fA
2 pA 20 fA
5 pA 50 fA
10 pA 100 fA
20 pA 200 fA
50 pA 500 fA
100 pA 1 pA
200 pA 2 pA
500 pA 5 pA
1 nA 10 pA
2 nA 20 pA
5 nA 50 pA
10 nA 100 pA
20 nA 200 pA
50 nA 500 pA
100 nA 1 nA
200 nA 2 nA
500 nA 5 nA
1 µA 10 nA