Demonstration Software; Ordering Information; Delivery Recommendations; Conventions - STMicroelectronics STM32L476 User Manual

Demonstration software

5 Demonstration software
The demonstration software, included in the STM32Cube MCU Package corresponding to
the on-board MCU, is preloaded in the STM32 Flash memory for easy demonstration of the
device peripherals in standalone mode. The latest versions of the demonstration source
code and associated documentation can be downloaded from the www.st.com/stm32l4-
discovery web page.
6

Ordering information

To order the 32L476GDISCOVERY Discovery kit, refer to
7

Delivery recommendations

Some verifications are needed before using the board for the first time to make sure that
nothing has been damaged during the shipment and that no components are unplugged or
lost. When the board is extracted from its plastic bag, check that no component remains in
the bag. In particularly, make sure that the following jumpers on top side of the board are
plugged: CN3, JP3, JP5, and JP6.
The battery CR2032 is not provided.
8

Conventions

Table 2
8/41

Table 1. Ordering information

Order code
32L476GDISCOVERY
provides conventions used in the present document.

Table 2. ON/OFF conventions

Convention
Jumper JPx ON
Jumper JPx OFF
Solder bridge SBx ON
Solder bridge SBx OFF
SBx connections closed by solder
UM1879 Rev 4
Table 1.
Target STM32
STM32L476VGT6
Definition
Jumper fitted
Jumper not fitted
SBx connections left opened
UM1879