Installation Requirements - Cisco Prisma II Installation Manual

Important Safety Instructions
is essential to safe operation and must be verified before connecting the power
supply.
Know the following safety warnings and guidelines:
Dangerous Voltages

- Only qualified service personnel are allowed to perform equipment
installation or replacement.
- Only qualified service personnel are allowed to remove chassis covers and
access any of the components inside the chassis.
Grounding

- Do not violate the protective grounding by using an extension cable, power
cable, or autotransformer without a protective ground conductor.
- Take care to maintain the protective grounding of this equipment during
service or repair and to re-establish the protective grounding before putting
this equipment back into operation.
Installation Site
When selecting the installation site, comply with the following:
Protective Ground - The protective ground lead of the building's electrical

installation should comply with national and local requirements.
Environmental Condition – The installation site should be dry, clean, and

ventilated. Do not use this equipment where it could be at risk of contact with
water. Ensure that this equipment is operated in an environment that meets the
requirements as stated in this equipment's technical specifications, which may be
found on this equipment's data sheet.

Installation Requirements

WARNING:
Allow only qualified service personnel to install this equipment. The
installation must conform to all local codes and regulations.
x