Cisco Prisma II Installation Manual page 158

Appendix A
Module Parameter Descriptions
Parameter ICIM
Name (LCI) Abbreviation
Rx Mode RxMode
1
RF Ports RxPorts
Node Select NodeSel
Note: All parameters below this point in the table relate to the attached node and are monitor-only.
Node NodeTemp
Temperature
PS 24V Node+24V
PS 7V Node+7V
PS AC NodeAC
Forward Mode
NdFwdMod
156
Description
Sets the receiver operating mode
1
2.5GHz or 5GHz.
Note: Changing the Rx Mode forces
the FPGA to be reprogrammed.
This takes about 10 seconds, so user
may notice a delay before the
change takes effect.
Sets whether the RF output is gated
to both connectors or just the top
connector. Refer to block diagrams
in page 28.
Selects the node to be monitored
(Node 1 to Node 4)
Indicates the temperature of the
node interior
Indicates the actual voltage on the
+24V rail of the node power supply
bus.
Indicates the actual voltage on the
+7V rail of the node power supply
bus.
Indicates the AC voltage at the
node AC power input.
Sets the forward mode for the node.
In Redundant mode, the node
automatically selects between one
of two forward receivers, FRx1 or
FRx2.
In Segmented or Single mode, only
one receiver (determined during
node setup) will be active and
selected.
Values Default
0: 5GHz 5GHz
1: 2.5GHz
1 1
2
1: Node 1 1
2: Node 2
3: Node 3
4: Node 4
degC N/A
V N/A
V N/A
V N/A
0: Segmented N/A
1: Redundant
2: Single