Cisco Prisma II Installation Manual page 147

Parameter ICIM
Name (LCI) Abbreviation
Mode Select Mode
Enable 1 Enable1
Enable 2 Enable2
Enable 3 Enable3
Enable 4 Enable4
Rx Input 1 Enable Rx1Inp1
Rx Input 2 Enable Rx1Inp2
Rx Input 3 Enable Rx2Inp1
Rx Input 4 Enable Rx2Inp2
RF Atten 1 RFAtten1
RF Atten 2 RFAtten2
Manual Alarm Alarm
1 2
Description
Module redundancy control. If set
to Master, the unit is only
controlled by the Enable control.
If set to Slave, the unit is controlled
by the Enable control and the
external input CNT_IN.
If set to Single, Rx1 to Rx4 will
continue to operate (i.e. not switch)
even if the optical input level falls
below the major alarm threshold.
Enables or disables Rx1 to Rx4. If
set to Off, the receiver is muted (RF
amplifier turned off), alarms are
inhibited, and redundancy is turned
off.
This control is mainly intended for
troubleshooting. It allows one to
disable individual streams from
appearing on the output. Note that
the B only setting only applies to
the 5GHz Rx mode.
Sets the RF attenuation for output A
or output B.
Note: In one RF output operation
mode, RF Atten 1 controls the
combined RF signal for input 1 and
input 3 , RF Atten 2 controls the
combined RF signal for input 2 and
input 4.
Force alarm if the Enable control is
1
On.
Receiver Parameters for GS7000 Nodes
Values
0: Slave
1: Single
2: Master
0: Off
1: On
0 = Both off
1 = A only
2 = B only
3 = Both on
0 to 10 dB in 0.5
dB steps
0: Off
1: On
Default
Single
On
Both On
0 dB
Off
145