Cisco Prisma II Installation Manual page 148

Appendix A
Module Parameter Descriptions
Parameter ICIM
Name (LCI) Abbreviation
Rx Mode RxMode
1
RF Ports RxPorts
Node Select NodeSel
Note: All parameters below this point in the table relate to the attached node and are monitor-only.
Path 1 NdPth1Rd
Redundancy
NdPth2Rd
Path 2
Redundancy
Node NodeTemp
Temperature
PS 1 Status NdPS1Flt
PS 2 Status NdPS2Flt
AC Status NdACFlt
PS 1 24V NdPS1+24
PS 2 24V NdPS2+24
Tx 1 Power Level NdTx1Pwr
Tx 2 Power Level NdTx2Pwr
Tx 3 Power Level NdTx3Pwr
Tx 4 Power Level NdTx4Pwr
146
Description
Sets the receiver operating mode
1
2.5GHz or 5GHz.
Note: Changing the Rx Mode forces
the FPGA to be reprogrammed.
This takes about 10 seconds, so user
may notice a delay before the
change takes effect.
Sets whether the RF output is gated
to both connectors or just the top
connector. Refer to block diagrams
on page 28.
Selects the node to be monitored
(Node 1 to Node 4)
Selects the redundancy mode for
the node connected to the Rx1 or
Rx2 optical path: Primary,
Redundant, or Failure.
Node temperature in degrees C
Indication that one or more PS1 or
PS2 voltages are out of spec.
Indicates that the AC power input
is either too high or too low.
Indicates the actual output voltage
of the PS1 or PS2 +24 VDC power
supply.
Indicates the output power of Tx1,
Tx2, Tx3, or Tx4.
Values Default
0: 5GHz 5GHz
1: 2.5GHz
1 1
2
1: Node 1 1
2: Node 2
3: Node 3
4: Node 4
0: N/A
1: Primary
2: Redundant
3: Failure
degC
0: OK
1: Fault
0: OK
1: Fault
V N/A
dBm