Cisco Prisma II Installation Manual page 29

2:1 Input (5 GHz), Two RF Outputs, One OPM

2:1 Input (5 GHz), Two RF Output, Two OPMs

The factory default operating mode is 2:1 Input, One RF Output, Two OPMs; other
modes can be selected by the user. For additional details on these operating modes,
see Receiver Operating Modes (on page 28).
Additionally, the receiver can be operated in any of three redundancy modes:
Master, Slave, or Single. When the receiver module is placed in Single operating
mode, four receiver channels in the module will continue to operate even if the
optical input level falls below the major alarm threshold.
Key operating parameters of the receiver and the transmitter at the node can be
controlled and monitored by an ICIM2 or ICIM2-XD, LCI software, ROSA software,
CLI commands, or the ICIM Web Interface. See Module Parameter Descriptions (on
page 141) for details.
Note: Node data is only available for GS7000 Nodes that have a transponder-less
LCM installed and an interface cable installed between transmitter and LCM. For
details, see the GS7000 GainMaker Scalable 4-Port Node Installation and Operation Guide.
Some transmitter data is available in all cases.
27