Replacing The Dust And Water Filter; Device Settings; Factory Setting - Dräger Pac 6000 Technical Manual

7.6

Replacing the dust and water filter

1. Place the special tool on the dust and water separator.
2. Press the lever on the special tool downward and then
remove the dust and water separator.
3. Insert a new dust and water separator. The dust and water
separator must click into place.
4 units
Sensor grille:
Order no.:
Pac 6xx0 83 26 853
Pac 8xx0 83 26 852
For special gases (ozone, phosgene), the entire front casing,
including the special diaphragm, must be replaced due to the
special diaphragm.
Front casing:
Pac 8000 ozone
Pac 8000 phosgene
8
Only trained and qualified personnel may change the device
settings.
8.1
The factory settings may differ for customised orders.
Bump test mode
Vibration alarm
Bump test interval
Operation signal
D-Light
Switch off
Data logger interval
Usage duration (user)
00633742.eps
40 units
Order no.:
83 26 857
83 26 859
Order no.:
83 26 851
83 26 854

Device settings

Factory setting

Quick bump test
On
Off
On
On
Always
1 min
Off
Device settings en
15