Ricoh IS300e Operating Instructions Manual page 80

Configuring the Scanner Settings
The following illustrates the refer-
ence point and actual scanning
area in accordance with the place
where you set the originals.
A
When the document is set in
document glass
3
When you place the originals on
the exposure glass, the available
area for scanning is 300mm
(11.8") (vertical) and 432mm
(17") (horizontal) from the ref-
erence point, regardless of the
setting in [Scan Type]. Be sure to
specify [Position] and [Scanning
Area] to be within the available
area for scanning.
B
When you place the originals in
the ADF
When you place the originals in
the ADF, the available area for
scanning is as follows depending
on the setting in [Scan Type] and
[Original Settings].
72
• When [Scan Type] is set to "
Black and White:Text ",
" Black and White:Text/
Photo " or " Black and White&
colon;Photo " and [Original Set-
tings] is set to a 1-sided option:
297mm (11.7") (vertical) and
2000mm (78.7") (horizontal)
from the reference point
• When [Scan Type] is set to other
than the above, and [Original Set-
tings] is set to a 1-sided option:
297mm (11.7") (vertical) and
630mm (24.8") (horizontal)
from the reference point
• When [Original Settings] is set to
ADG012S
a 2-sided option:
297mm (11.7") (vertical) and
432mm (17") (horizontal) from
the reference point
Be sure to specify [Position] and
[Scanning Area] to be within the
available area for scanning.
Note
❒ The inside line of the original ta-
ble's guide on the side of the
control panel exactly passes the
vertical reference point for the
ADF scanning, when the guide
is fully expanded.
❖ ❖ ❖ ❖ Image Density
This item lets you select the scan
density in one of the seven steps.
The larger the value, the darker the
scanned image becomes.
ADG013S