Simplex Scanning - Ricoh IS300e Operating Instructions Manual

Simplex Scanning

The setting orientation differs depending on whether the width of original is
within or larger than 297mm (11.7").
Original width
When placing an original
on the exposure glass
⇒ p.116 "Placing the
Original on the Exposure
Glass"
When placing originals
on the ADF
⇒ p.117 "Placing the
Originals in the ADF"
Setting when the net-
work TWAIN driver is
used
Settings for Send Scan
(Use [Original Settings] in
[Scan Settings] )
*1
Contact glass: Select when scanning from the exposure glass.
297mm (11.7") or less
Place the original so that the top
edge touches the top-left of the
exposure glass.
Place the top edge of the original
first.
Set [Orientation:] to
When the ADF is used, set [Side:]
to " Simplex ".
Note
❒ Set " ADF " or " Platen glass
*1
" in [ Document: ].
Select [ : 1 Sided].
Note
❒ Because this is the initial val-
ue of this setting, you do not
need to change it.
wider than 297mm (11.7")
Place the original so that the top
edge touches the top-left of the
exposure glass.
Place the original so that the top
edge is set on the far side of the
original table.
. Set [Orientation:] to
When the ADF is used, set [Side:]
to " Simplex ".
Note
❒ Set " ADF " or " Platen glass
*1
" in [ Document: ].
Select [ : 1 Sided].
Original Orientation
.
113
4