Configuration procedure
To configure a static FC route:
Step
1.
Enter system view.
2.
Enter VSAN view.
3.
Configure a static FC
route.
Configuring FSPF
FSPF is enabled by default. Typically, you do not need to perform special tasks.
You can change FSPF parameters on a per-VSAN or per-interface basis.
FSPF configuration task list
Tasks at a glance
Change FSPF parameters for a VSAN in VSAN view
•
(Required.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
(Optional.) Change FSPF parameters for an interface in E_Port interface view
•
Setting the FSPF cost for an interface
•
Setting the hello interval for an interface
•
Setting the dead interval for an interface
•
Setting the LSR retransmission interval for an interface
•
Disabling FSPF for an interface
(Optional.)
•
Configuring the GR restarter
•
Configuring the GR helper
Enabling FSPF
FSPF-related features can work in a VSAN only after you enable FSPF in the VSAN.
To enable FSPF:
Step
1.
Enter system view.
Command
system-view
vsan vsan-id
fc route-static fcid { mask | mask-length }
interface-type interface-number [ cost
cost-value ]
Enabling FSPF
Setting the shortest SPF calculation interval
Setting the minimum LSR arrival interval
Setting the minimum LSR refresh interval
Configuring FSPF GR
Command
system-view
Remarks
N/A
56
Remarks
N/A
N/A
By default, no static FC route exists.